Leading 10 typical forklift crashes ， forklift procedure need to take note of these issues ！.

Leading 10 typical forklift crashes ， forklift procedure need to take note of these issues ！.

Blog Article

Do not ignore the forklift at the office. If the operation is not good, there will certainly be severe crashes in minutes, and there are many crashes including forklifts.

Case 1: The forklift freight blocked the driver's view, and the person ahead might not be located, leading to a rolling crash.
Situation 2: In order to maintain the balance of the forklift when raising hefty products, the staff members utilized their body weight as the counterweight, which virtually triggered casualties.
Case 3: The size of the forklift freight surpasses the allowable width of the course and hangs on the roadside shelf, which virtually causes an mishap.
Instance 4: Forklift is speeding and surrender throughout a turn.
Case 5: The forklift motorist did not notice the pedestrian, and the pedestrian did not discover the forklift.
Situation 6: The forklift raises the employees illegally, the forklift motorist does not put on the seat belt, the forklift lifter falls and the chauffeur is crushed when the forklift surrender.
Case 7: The forklift motorist did not wear a seat belt and fell from the automobile when it surrendered and was squashed.
Forklift procedure must pay attention to these matters ：.

Start.
1. Before starting, observe the surroundings, and after verifying that there are no challenges that impede the safety and security of driving, beep the horn initially and then begin.
2. For lorries with hydraulic ( atmospheric pressure) brakes, the brake hydraulic stress ( atmospheric pressure) scale must be secure prior to starting.
3. When the forklift starts with a load, the driver needs to initially verify that the tons is stable and trustworthy.
4. The begin should be slow and constant.

Driving.
1. When driving, the height in between the bottom end of the fork and the ground ought to be kept at 300mm-400mm, and the pole needs to be tilted backward. .
2. Do not raise the fork too expensive when driving. When entering and leaving the work site or while driving, be careful that there will certainly be no challenges in the sky. When the lots is traveling, the fork has to not be raised expensive, which will influence the stability of the forklift. .
3. After dumping, the fork needs to be reduced to the normal driving setting prior to driving. .
4. When turning, if there are pedestrians or automobiles nearby, the driving signal needs to be provided first. High-speed doglegs are forbidden. High-speed sharp turns will create the lorry to lose lateral security and topple. .
5. When the forklift is downhill, it is strictly prohibited to turn off the flame and slide, and it is prohibited to brake suddenly while driving with lots unless there are unique situations.
6. When the forklift is running, it must follow the website traffic rules in the manufacturing facility and should keep a specific safety distance from the lorry ahead. .
7. When the forklift is running, the lots has to remain in the most affordable placement that does not prevent the driving, and the gantry needs to be appropriately slanted back. The lots will not be increased except when stacking or loading. .
8. The height of the load must not obstruct the motorist's sight. In special situations, when the product impacts the forward vision, drive at a reduced speed when reversing.
9. It is restricted to activate the ramp, neither to drive across the ramp. .
10. The safe driving rate of the forklift in the factory area is 5 km/h, and it needs to drive safely at a low rate when getting in the manufacturing workshop location. .
11. When the forklift is lifted, lifted or driven, it is forbidden for employees to depend on the fork to hold products and play a balancing duty. .
12. If issues are found, they will be fixed and reported in a timely manner, and they will certainly never run with health problems or conceal them.

loading and discharging.
1. When fork-loading items, the range between both forks ought to be readjusted as required to make the lots of the two forks balanced and not skewed, and one side of the thing ought to protest the rack. .
2. It is restricted to deal with a single fork or make use of a fork top or pull. In special conditions, safety warning signs need to be established to advise bordering pedestrians. .
3. In the process of packing and dumping products, the forklift must be stopped with the brake. .
4. The rate of the automobile should be sluggish and steady. Beware not to roll the wheels on the dunnage, so as not to extend the rolled objects and hurt people. .
5. When utilizing a fork to fork the goods, the fork must be as deep as feasible under the tons, and it must be kept in mind that the fork tip ought to not touch other goods or items. The tons should be supported with marginal back tilt of the gantry so that the load does not move backwards. The mast can be slanted ahead somewhat when the tons is decreased to permit easy placement of the tons and removal of the forks. .
6. It is restricted to fork products at high speed and collide with tough items with the fork head. .
7. When the forklift is working, it is prohibited for individuals to loaf the fork, so as to prevent the collapse of the goods and hurt individuals. .
8. Overloading is prohibited, and it is prohibited to use forks to lift personnel to take part in high-altitude operations to prevent high-altitude falling crashes. .
9. It is not allowed to use the brake inertia to slip, put, round or roll things. .
10. It is not enabled to use forks to pick, transform pallet discharge.

Leaving .
1. It is restricted to leave the forklift when the things on the fork are in the air. Prior to leaving the forklift, you should discharge the goods or reduced the fork structure.
2. Draw the parking brake manage to dead or dispirit the parking brake button.
3. The engine is turned off and the power is removed. (Except for unique circumstances, such as the vehicle driver does not leave the automobile's line of vision and does not surpass 1 min).
4. Eliminate the key. .

Forklift Operation Precautions.
1. Before and after the forklift operation, the look must be examined, and fuel, lubing oil and cooling water need to be included.
2. Inspect the safety and security efficiency of starting, running and stopping.
3. Inspect whether the lights and horn signals are total and efficient.
4. Throughout the operation of the forklift, inspect whether the pressure and temperature are normal.
5. After the forklift is running, the exterior leak must likewise be checked and the seals must be changed in time.

Forklift Safety Operation Specifications.
1. You must examine prior to leaving the cars and truck;.
2. When you run into somebody in front of you throughout driving, you must send a signal at a distance of 5 m;.
3. The driving rate in the factory does not exceed 5 km/h;.
4. When driving, the nadir of the cargo need to be 0.3 m ~ 0.4 m in Electric Forklift Truck for Warehouse the air;.
5. The turning need to not be too sharp to avoid the tendency of "free switching";.
6. Adding and down the incline should be slow-moving and uniform, and no switching on the slope is enabled.
7. Do not drive across the gradient. When the slope is higher than 10%, the vehicle should be driven in reverse when worsening;.
8. When the forklift personnel lug the goods and move on, if they experience big or heavy goods and most likely Stand-on Electric Pallet Stacker to the chauffeur's line of sight, they must take the reversing workout
.
The "Eight Prohibitions" should be complied with in the procedure.
1. Single fork procedure is not allowed.
2. It is not enabled to raise the goods for long distance driving.
3. It is not permitted to pick up the goods by handing over the pallet with the fork.
4. It is not permitted to directly shovel chemicals, flammables and other unsafe chemicals with forks.
5. It is not allowed to utilize inertia pressure to pick up the goods.
6. It is not allowed to utilize stopping force to exile round or easy-to-roll items.
7. It is not permitted to bring individuals to deal with the pallet or fork, and it is strictly restricted to stand under the fork after the fork is raised.
8. Do not drive laterally on slopes
.
Parking is not permitted under the following conditions.
1. Curves, narrow roads, train crossings;.
2. Areas with a longitudinal incline greater than 5%.
3. When there is an obstacle on one side of the road, the opposite side of the section with the same length as the challenge must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844